Building construction's

We produce everything needed for breakout arm. The construction arm from Ukrkomplekt easily and quickly assembled and disassembled with the help of carabiners. Durable thanks to the speed bumps. It is possible to mount with the mounting frames to the window openings, balconies or the metal scaffolding. Construction rubble discharger chutes are designed to remove debris from floors under construction or repaired buildings. Using the arm, possibly, removal of debris with simultaneous loading in garbage containers or the car body. The arm saves money, as the reduced costs of garbage removal and loading of waste containers. Also the arm increases safety when carrying out construction works. The description of the components and Assembly rules The column of construction rubble discharger chutes consists of a set of direct and foster sleeveless, made of high-strength polyethylene. The sleeves are interconnected by means of steel chains and snap hooks. The straight sleeve is designed to direct the debris down the column of construction rubble discharger chutes. The receiving sleeve is designed to receive construction debris, and set at the top of the column. Foster floor sleeve is designed to receive debris, and is set in the column of construction rubble discharger chutes in the places of dumping garbage workers. Frame bracket to the building wall thickness from 10 to 70cm, with the help of special clamps. When installation of the column of the rubbish chutes, the upper receiving sleeve is attached with the top frame, bracket, and all others with intermediate. Between the elements of the arm in this case you set of metal speed bumps. Rules of operation In order to avoid the congestion of debris in the elements of the construction's not discard pieces of debris larger than 35 cm or in bulk at the same time pieces larger than 20 cm, sharp pieces of metal, rebar and glass. For reliable operation and to prevent breakdown of the actions of significant dynamic loads discharged from the garbage, it is necessary every 10 – 15 cones set of metal speed bumps. To fix the construction's column, you should only use the brackets supplied or agreed with the manufacturer. When assembling, observe the rule: when the chutes are displayed, the lower section of the upper cone must be below the upper edge of the lower chute is not less than 100 mm.